ES 330 V6-3.3L (3MZ-FE) (2004)
A.
Position the door trim seal (P/N: 67745-33021). There is a step 140 mm (5.5 in.) behind the courtesy lamp on the door trim. Place the rear
end of the door trim seal flush against the step as shown (Figure 3).
B.
Pull up the lip area away from the door panel as shown below (Figure 4).
C.
Position the staple gun so that the staple can be located 2 mm (0.08 in.) away from the corner of the lip area as shown below (Figure 5).