lexus Workshop Repair Guides

Lexus Workshop Service and Repair Manuals

Camshaft (LH)|Page 1488 > < Camshaft (LH)|Page 1486
Page 7
background image

d. Install the oil seal to the camshaft.

NOTICE:  
^

Do not turn over the oil seal lip.

^

Insert the oil seal until it stops.

e. Remove any old packing material from the contact sur face.

f.

Apply seal packing to the bearing cap No. 1 as shown in the illustration. Seal packing: Part No. 08826-00080 or equivalent

NOTICE:  
^

Install the bearing cap No. 1 within 5 minutes after applying seal packing.

^

Do not expose the seal packing to engine oil within 2 hours after installing.

g. Install the 5 bearing caps in their proper locations.
h. Apply a light coat of engine oil to the threads of the bearing cap bolts.

i.

Using several steps, install and tighten the 10 bearing cap bolts uniformly in the sequence shown in the illustration. 
Torque: 16 Nm (163 kgf-cm, 12 ft. lbs.)

30. INSTALL NO.3 CAMSHAFT SUB-ASSY

NOTICE:  Since the thrust clearance of the camshaft is small, the camshaft must be kept level while being installed. If the camshaft is not kept
level, the cylinder head or camshaft may be damaged. To avoid this, the following steps must be carried out.

Camshaft (LH)|Page 1488 > < Camshaft (LH)|Page 1486