ES 330 V6-3.3L (3MZ-FE) (2004)
Impact Sensor: Service and Repair
Seat Position Airbag Sensor
REPLACEMENT
HINT: Installation is in the reverse order of removal.
1. OBSERVE AIR BAG SYSTEMS SERVICE PRECAUTIONS
2. DISCONNECT BATTERY NEGATIVE TERMINAL
3. REMOVE FRONT SEAT ASSY LH
4. REMOVE RECLINING POWER SEAT SWITCH KNOB
5. REMOVE SLIDE & VERTICAL POWER SEAT SWITCH KNOB
6. REMOVE FRONT SEAT CUSHION SHIELD INNER NO.1 LH
7. REMOVE FRONT SEAT CUSHION SHIELD LH
8. REMOVE SEAT SLIDE POSITION SENSOR PROTECTOR
(a) Remove the seat slide position sensor protector from the seat position airbag sensor.
9. REMOVE SEAT POSITION AIR BAG SENSOR
(a) Disconnect the connector from the seat position airbag sensor.
(b) Using a torx socket wrench (T30), remove the torx screw and the seat position airbag sensor.
10. INSTALL SEAT POSITION AIR BAG SENSOR
(a) Check that the ignition switch is off.
(b) Check that the battery negative (-) terminal is disconnected.
CAUTION: After removing the terminal, wait for at least 90 seconds before starting the operation.