ES 330 V6-3.3L (3MZ-FE) (2004)
8.
Recheck the position of the triangle mark on the Front Coil Spring Seat Upper in relation to the strut centerline. If the triangle mark is not 0.5 inch
(12.5 mm) COUNTERCLOCKWISE from the centerline of the strut, repeat the procedure above.
9.
Recheck the position of the coil spring in the lower spring seat and tighten the upper lock nut to specification.
CAUTION:
Inspect the coil spring to verify the painted surface of the spring has not been damaged.
If necessary, use touch-up paint to cover any areas where paint has been removed.
10.
Reinstall the both Front Strut Assemblies following the instructions in the Technical Information System (TIS), 2004 model year ES 330 Repair
Manual, Front Suspension: Front Shock Absorber With Coil Spring.
11.
Check the vehicle alignment and follow the remaining repair procedures per TSIB No. ST004-01, "Repair Manual Supplement: Vehicle Pulling to
One Side."
12.
Perform Zero Point calibration after setting the alignment to specification. Refer to TSIB No. BR001-04, "Zero Point Calibration, " for Zero Point
reset procedure.
Technical Service Bulletin # ST003-04
Date: 040204
Steering/Suspension - Vehicle Pulls to The Left
STEERING
ST003-04
February 4, 2004
Title
VEHICLE PULL IMPROVEMENT PROCEDURE
Models
'04 ES 330
Introduction
This service bulletin is to inform you of the repair procedure for the 2004 model year ES 330 vehicles pulling to the left. Please use these repair methods
in conjunction with the Repair Manual instructions.
Applicable Vehicles
^
2004 model year ES 330 vehicles produced BEFORE the Production Change Effective VINs shown below.
Production Change Information