ES 330 V6-3.3L (3MZ-FE) (2004)
m. Wind vinyl tape around the serration part of the control valve.
n. Install the dust cover to the control valve housing.
49. INSTALL STEERING RACK END SUB-ASSY
a. Install a new 2 claw washers, and temporarily install the 2 steering rack ends sub-assy.
HINT: Align the claws of the claw washer with the power steering rack grooves.
b. Using 2 SSTs, install the 2 steering rack ends sub-assy.
SST 09922-10010
Torque: 58.5 Nm (597 kgf-cm, 43 ft. lbs.)
NOTICE: Use SST 09922-10010 in the direction shown in the illustration.
HINT:
^
Using SST, hold the power steering rack and install the steering rack end sub-assy.
^
Use a torque wrench with a fulcrum length of 345 mm (13.58 inch).
c. Using a brass bar and a hammer, stake the claw washer.
NOTICE: Avoid any impact to the power steering rack.