ES 330 V6-3.3L (3MZ-FE) (2004)
d. Install the coil spring to the shock absorber.
HINT:
^
Fit the lower end of the coil spring into the gap of the lower seat.
^
Check that the 2 flat faces of the piston rod are position in parallel with the 2 flat faces of the rear suspension support.
e. Align the suspension support with the shock absorber lower bracket, as shown in the illustration.
HINT: Set the suspension support so that the ribbed part of the suspension support faces out side.
f.
Install the collar to the piston rod.
g. Temporarily install a new nut.
h. Remove the SST.
SST 09727-30021
HINT: After removing SST, recheck the direction of the suspension support.
20. INSTALL REAR SHOCK ABSORBER WITH COIL SPRING
a. Install the shock absorber with the coil spring and 3 nuts.
Torque: 39 Nm (400 kgf-cm, 29 ft. lbs.)