ES 350 V6-3.5L (2GR-FE) (2007)
g. Remove the front door inside locking cable assembly.
INSTALLATION
1. INSTALL FRONT DOOR LOCK ASSEMBLY
NOTE:
-
When reusing the removed front door lock assembly, replace the door lock wiring harness seal on the connector with a new one.
-
Do not allow grease or dust to adhere to the door lock wiring harness seal surface of the connector.
-
Reusing the door lock wiring harness seal or using a damaged door lock wiring harness seal may cause water intrusion to the connection. This
may result in a malfunction of the front door lock assembly.
a. Install the front door inside locking cable assembly.
b. Engage the 3 claws.
c. Install the front door lock remote control cable assembly.
d. Apply MP grease to the sliding parts of the front door lock assembly.