ES 350 V6-3.5L (2GR-FE) (2007)
d. Remove the 3 bolts and the brake actuator with brake actuator bracket assembly from the body.
NOTE: Do not damage the brake lines and wire harness.
INSTALLATION
1. INSTALL BRAKE ACTUATOR WITH BRAKE ACTUATOR BRACKET ASSEMBLY
a. Install the brake actuator with brake actuator bracket assembly to the body with the 3 bolts.
Torque: 19 N.m (194 kgf.cm, 14 ft.lbf)
NOTE: Do not damage the brake lines and wire harness.
b. Temporarily tighten each brake line to the correct positions of the brake actuator with brake actuator bracket assembly as shown in the
illustration.
HINT:
-
*1: To Front Wheel Cylinder RH
-
*2: To Front Wheel Cylinder LH
-
*3: To Rear Wheel Cylinder RH
-
*4: To Rear Wheel Cylinder LH
-
*5: From 1st Master Cylinder