ES 350 V6-3.5L (2GR-FE) (2007)
Warranty Information
Repair Procedure
1.
Connect the Diagnostic Tester to the DLC3 connector.
2.
Enter the following menus on the tester:
OBD/MOBD / ENGINE / DATA LIST / A/T OIL TEMP
NOTE:
The A/T fluid temperature should be less than 104°F (40°C) before beginning the fluid temperature check.
3.
Circulate the A/T fluid.
A.
Start the engine in Park.
B.
Move the gear selector from Park to Reverse.
C.
Move the gear selector from Reverse to Neutral.
D.
Move the gear selector from Neutral to Drive.
E.
Return the gear selector to the Park position.
NOTE:
^
Allow each gear to engage fully when performing this step.
^
The A/T fluid temperature MUST be between 104°F (40°C) and 113°F (45°C) to accurately check the fluid level.
4.
Check the A/T fluid level.
A.
Allow the engine to idle until the A/T fluid temperature reaches 102°F (39°C).
B.
Remove the overflow plug with the engine idling.