ES 350 V6-3.5L (2GR-FE) (2007)
8. REMOVE FRONT AXLE ASSEMBLY
(a)
Put matchmarks on the front drive shaft assembly and the front axle hub sub-assembly.
(b) Using a plastic hammer, separate the front drive shaft assembly from the front axle assembly.
NOTICE: Be careful not to damage the drive shaft boot or speed sensor rotor.
(c)
Remove the 2 bolts, 2 nuts, and front axle assembly.
9. REMOVE NO. 1 FRONT WHEEL BEARING DUST DEFLECTOR
(a)
Using a screwdriver with its tip wrapped with vinyl tape, remove the No. 1 front wheel bearing dust deflector.
NOTICE: Be careful not to damage the steering knuckle.
10. REMOVE FRONT AXLE HUB HOLE SNAP RING
(a)
Using snap ring pliers, remove the front axle hub hole snap ring.