ES 350 V6-3.5L (2GR-FE) (2007)
HINT: *1:If After Exchange is selected before the previous ECU data are stored in the intelligent tester, the display screen returns to
CONDITION SELECT ECU: Occupant Detect.
2. SENSITIVITY CHECK
a. Sensitivity check procedures
1. Turn the engine switch off.
2. Place a weight of 20 kg (44.0 lb) on the front passenger seat.
NOTE:
-
Do not allow the weight to come into contact with the seatback when placing it on the seat cushion.
-
Place the weight in the area shown in the illustration.
3. Turn the engine switch on (IG), and wait for at least 6 seconds.
4. Check that the passenger airbag ON/OFF indicator indicates OFF.
OK:The passenger airbag ON/OFF indicator indicates OFF.
5. Add a weight of 30 kg (66.1 lb) to the front passenger seat (total 50 kg (110.2 lb)).
NOTE:
-
Do not allow the weight to come into contact with the seatback when placing it on the seat cushion.
-
Place the weight in the area shown in the illustration.
6. Check that the passenger airbag ON/OFF indicator indicates ON.
OK:The passenger airbag ON/OFF indicator indicates ON.
Registration
REGISTRATION
NOTE:
-
If any DTCs related to the occupant classification ECU are output, troubleshoot those DTCs by referring to the DIAGNOSTIC TROUBLE CODE
CHART.
-
When ECU data saving or loading operations cannot be performed, replace the front seat cushion assembly (with occupant classification ECU and
occupant classification sensor).
HINT:
-
When the occupant classification ECU is replaced, the previous ECU data must be saved in the intelligent tester and loaded into the new ECU by
following the flowchart.
-
Until the data from the previous ECU are loaded into the new occupant classification ECU, these data are not erased even when the tester is turned
off.
-
ECU EXCHANGE PROCEDURE (Before Exchange) describes the procedure to save the data in the intelligent tester from the occupant