ES 350 V6-3.5L (2GR-FE) (2007)
a. Disconnect the connector.
b. Remove the 2 bolts.
c. Disengage the claw and clip and remove the seat belt control ECU.
INSTALLATION
1. INSTALL SEAT BELT CONTROL ECU
a. Engage the claw.
b. Engage the clip.
c. Install the seat belt control ECU with the 2 bolts.
Torque: 5.0 N.m (51 kgf.cm, 44 in.lbf
d. Connect the connector.
2. INSTALL LUGGAGE COMPARTMENT INNER TRIM COVER RH
3. INSTALL REAR FLOOR FINISH PLATE
4. INSTALL NO. 1 LUGGAGE COMPARTMENT TRIM HOOK
5. INSTALL LUGGAGE HOLD BELT STRIKER ASSEMBLY 89
6. INSTALL SPARE WHEEL COVER TRAY
7. INSTALL LUGGAGE COMPARTMENT FLOOR MAT
8. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
9. PERFORM INITIALIZATION
NOTE: Some systems need initialization after reconnecting the cable to the negative battery terminal.
10. INSPECT SRS WARNING LIGHT