ES 350 V6-3.5L (2GR-FE) (2007)
e. Remove the 2 clips.
f.
Disengage the hooks and remove the separate type front seat cushion assembly RH.
17. REMOVE OCCUPANT CLASSIFICATION SENSOR
a. Disconnect the connector.
b. Using a screwdriver, raise the claws on the bracket and pull out the connector in the direction indicated by the arrow in the illustration.
HINT: Tape the screwdriver tip before use.
c. Using a clip remover, disengage the 2 clips and remove the occupant classification sensor.
NOTE: When the occupant classification sensor is replaced, be sure to replace the occupant classification ECU as a set.
INSTALLATION
1. INSTALL OCCUPANT CLASSIFICATION SENSOR