ES 350 V6-3.5L (2GR-FE) (2007)
6. Check that the "VSC TEST MODE" is displayed on the multi information display (Test Mode).
HINT:
-
The SLIP indicator light remains on during Test Mode because TRAC is prohibited.
-
If the "VSC TEST MODE" is not displayed on the multi information display, perform zero point calibration again.
-
The zero point calibration is performed only once after the system enters the Test Mode.
-
Calibration cannot be performed again until the stored data is cleared.
7. Turn the engine switch off and disconnect the SST from the DLC3.