ES 350 V6-3.5L (2GR-FE) (2007)
(d) Move the slider in the direction indicated by arrow A and pull up the lock piece in the direction indicated by arrow B.
NOTICE: Do not damage the boot.
(e)
Install the control cable to the control shaft with the nut.
Torque: 13 N*m (130 kgf*cm, 9 ft.*lbf)
NOTICE:
^
If the control cable end is excessively pushed up, the shift lever cannot be adjusted.
^
When tightening the nut, confirm that the control cable is properly stretched.
(f)
Push in the lock piece.
NOTICE: Firmly push in the lock piece until the slider lock is engaged.
(g) Start the engine and make sure that the vehicle moves forward when moving the lever from the N to the D position and moves rearward when
moving it to the R position. If it becomes hard to move the shift lever, readjust the shift lever position.
INSTALLATION