ES 350 V6-3.5L (2GR-FE) (2007)
3. INSTALL FRONT DRIVE SHAFT DUST COVER RH
(a)
Using SST and a press, install a new drive shaft dust cover RH until distance (A) from the tip of the center drive shaft to the drive shaft dust
cover RH meets the specification.
SST 09527-10011
Distance (A): 110.0 to 111.0 mm (4.3307 to 4.3701 in.)
NOTICE:
^
The dust cover should be completely installed.
^
Be careful not to damage the dust cover.
4. INSTALL FRONT DRIVE SHAFT DUST COVER LH
(a)
Using SST and a press, install a new drive shaft dust cover LH.
SST 09527-10011
NOTICE:
^
The dust cover should be completely installed.
^
Be careful not to damage the dust cover.
5. INSTALL FRONT AXLE OUTBOARD JOINT BOOT
(a)
Hold the drive shaft lightly in a vise between aluminium plates.
HINT: Before installing the boots, wrap the spline of the drive shaft with vinyl tape to prevent the boots from being damaged.
(b) Temporarily install a new outboard joint boot to the drive shaft with the 2 clamps.
(c)
Pack the outboard joint shaft and boot with grease.
Grease capacity: 164 to 184 g (5.8 to 6.5 oz.)