GS 350 AWD V6-3.5L (2GR-FSE) (2009)
Tire Pressure Monitor Receiver / Transponder: Service and Repair
Replacement
TIRE AND WHEEL: TIRE PRESSURE WARNING RECEIVER: REPLACEMENT
REPLACEMENT
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
NOTE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected See: Testing and Inspection/Programming
and Relearning.
2. REMOVE ROOF HEADLINING ASSEMBLY
HINT: Refer to the instructions for removal of the roof headlining assembly See: Body and Frame/Interior Moulding /
Trim/Headliner/Service and Repair/Removal.
3. REMOVE TIRE PRESSURE MONITOR RECEIVER ASSEMBLY
(a) Disconnect the connector.
(b) Remove the bolt and the tire pressure monitor receiver assembly.
4. INSTALL TIRE PRESSURE MONITOR RECEIVER ASSEMBLY
(a) Install the tire pressure monitor receiver assembly with the bolt.
Torque: 7.5 Nm (77 kgf-cm, 66 in-lbf)
(b) Connect the connector.
5. INSTALL ROOF HEADLINING ASSEMBLY
HINT: Refer to the instructions for installation of the roof headlining assembly See: Body and Frame/Interior Moulding /
Trim/Headliner/Service and Repair/Installation.
6. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected See: Testing and Inspection/Programming
and Relearning.
7. REGISTRATION TRANSMITTER ID
HINT:
See: Instrument Panel, Gauges and Warning Indicators/Tire Monitoring System/Testing and Inspection/Programming and Relearning/Registration.
8. INSPECT TIRE PRESSURE WARNING SYSTEM
HINT:
See: Instrument Panel, Gauges and Warning Indicators/Tire Monitoring System/Testing and Inspection/Initial Inspection and Diagnostic Overview/Test
Mode Procedure.