GS 350 AWD V6-3.5L (2GR-FSE) (2009)
Wiper Switch: Service and Repair
Installation
WIPER AND WASHER: WIPER SWITCH: INSTALLATION
INSTALLATION
1. INSTALL WINDSHIELD WIPER SWITCH ASSEMBLY
(a) Attach the claw and install the wiper switch.
(b) Connect the connector.
2. INSTALL SPIRAL CABLE WITH STEERING SENSOR See: Restraint Systems/Air Bag Systems/Clockspring Assembly / Spiral Cable/Service
and Repair/Installation
3. INSTALL STEERING COLUMN COVER See: Steering and Suspension/Steering/Steering Column/Service and Repair/Removal and
Replacement/Installation
4. ADJUST SPIRAL CABLE WITH STEERING SENSOR See: Restraint Systems/Air Bag Systems/Clockspring Assembly / Spiral Cable/Service
and Repair/Installation
5. INSTALL STEERING WHEEL ASSEMBLY See: Steering and Suspension/Steering/Steering Column/Service and Repair/Removal and
Replacement/Installation
6. INSPECT STEERING WHEEL CENTER POINT
7. INSTALL STEERING PAD See: Restraint Systems/Air Bag Systems/Air Bag/Service and Repair/Steering Pad/Installation
8. INSTALL NO. 3 STEERING WHEEL COVER LOWER
9. INSTALL NO. 2 STEERING WHEEL COVER LOWER
10. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
11. INSPECT STEERING PAD See: Restraint Systems/Air Bag Systems/Air Bag/Service and Repair/Steering Pad/Installation
12. PERFORM INITIALIZATION
(a) Perform initialization See: Testing and Inspection/Programming and Relearning.
NOTE:
Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.
13. INSPECT SRS WARNING LIGHT
(a) Check the SRS warning light See: Restraint Systems/Air Bag Systems/Testing and Inspection/Initial Inspection and Diagnostic
Overview/Diagnosis System.