GS 350 RWD V6-3.5L (2GR-FSE) (2007)
a. Disconnect the connector.
b. Remove the 3 screws and speaker.
HINT: Do not touch the cone part of the speaker.
INSTALLATION
HINT:
-
Use the same procedures for the LH side and RH side.
-
The procedures listed for the LH side.
1. INSTALL FRONT NO. 1 SPEAKER ASSEMBLY
a. Temporarily install the speaker by attaching the claws of the speaker to the door panel.
b. Install the speaker with the 3 screws.
HINT:
-
Install the screws in the order given in the illustration.
-
Do not touch the cone part of the speaker.
c. Connect the connector.
2. INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH
3. INSTALL FRONT DOOR INSIDE HANDLE BEZEL PLUG LH
4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
5. PERFORM INITIALIZATION
a. Perform initialization.
NOTE: Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.
Front No. 2 Speaker