Body - Moonroof Auto-Close Function Inoperative
^ Warranty application is limited to correction of a problem based upon a customer's specific complaint.
Initialization Procedure
NOTE
Before performing this initialization procedure:
^ Make sure that there is no foreign matter on the guide rail.
^ Make sure that the guide rails are not deformed.
NOTE
^ Do NOT switch any electrically powered systems ON and OFF during initialization.
^ If battery voltage fluctuates by 0.5V or more, initialization will fail.
^ Permanent ECU damage will occur if power is disconnected while the moon roof motor is operating.
^ Do NOT move the vehicle during re-initialization.
^ Do NOT apply strong force to the vehicle during the re-initialization, such as closing the door.
Initialization Procedure
Before beginning this procedure, make sure the moon roof is fully closed.
NOTE
If the moon roof will not close automatically use manual mode to close the moon roof. Quickly press and release the switch until the moon is closed.
1. Switch ON the ignition(IG) by pressing the START/STOP button twice or turn the engine key to IG position.
2. Push and hold the TILT UP switch until the moon roof reaches the full tilt up position, then release the switch.
NOTE
The tilt up position is the starting point for the moon roof motor to re-learn the positions.
3. Push and hold the TILT UP switch again. After approximately 10 seconds, moon roof will begin the initialization procedure. DO NOT release the
switch until the procedure is complete. The moon roof will tilt down, slide open, slide close and stop at the fully closed position. At this point the
initialization is complete and the tilt up switch may be released.
NOTE
If the TILT UP switch is released during the procedure, the buttons may not operate properly. The moon roof will have to be operated manually to start
the procedure over again.