lexus Workshop Repair Guides

Lexus Workshop Service and Repair Manuals

Component Tests and General Diagnostics|Page 6461 > < Component Tests and General Diagnostics|Page 6459
Page 3
background image

c. Turn the engine switch off and disconnect the intelligent tester.

4. CLEAR ZERO POINT CALIBRATION (WHEN USING SST CHECK WIRE:)

a. Turn the engine switch on (IG).
b. Using SST, connect and disconnect terminals TS and CG of the DLC3 4 times or more within 8 seconds.

SST 09843-18040

c. Check that the multi-information display indicates the normal system code.
d. Remove the SST from the terminals of the DLC3.
e. Using a check wire, perform zero point calibration of the yaw rate and acceleration sensor.

5. PERFORM ZERO POINT CALIBRATION OF YAW RATE AND ACCELERATION SENSOR (WHEN USING SST CHECK WIRE:)

NOTE:
-

While obtaining the zero point, do not vibrate the vehicle by tilting, moving or shaking it and keep it stationary. (Do not start the engine.)

-

Be sure to do this on a level surface (with an inclination of less than ).

a. Procedures for test mode.

1. Turn the engine switch off.
2. Using SST, connect terminals TS and CG of the DLC3.

SST09843-18040

3. Check that the steering wheel is centered and move the shift lever to the P position. 

Component Tests and General Diagnostics|Page 6461 > < Component Tests and General Diagnostics|Page 6459