lexus Workshop Repair Guides

Lexus Workshop Service and Repair Manuals

Brake Bleeding|Service and Repair|Page 6769 > < Brake Bleeding|Service and Repair|Page 6767
Page 4
background image

(3) Check that the operation has stopped by referring to the intelligent tester display and tighten the bleeder plug.
(4) Repeat (2) and (3) until all the air in the fluid is completely bled out.
(5) Using SST, tighten the bleeder plug completely.

SST 09023-00101
Torque: 11 N*m (112 kgf*cm, 8 ft.*lbf)

(6) For the rest of the wheels, bleed the air in the same way as stated in the above procedures.

(f)

Bleed the air from the pressure reduction line according to "Step 3: Decrease" on the intelligent tester display.

NOTICE: 
^

Bleed the pressure reduction line by following the steps displayed on the intelligent tester.

^

Make sure that the master cylinder reservoir tank does not become empty of brake fluid.

(1) Connect a vinyl tube to either one of the bleeder plugs.
(2) Loosen the bleeder plug.
(3) Using the intelligent tester, operate the ABS and TRACTION actuator assembly, completely depress the brake pedal and hold it.

NOTICE: 
^

The operation stops automatically in 4 seconds. When performing this procedure continuously, an interval of at least 20 seconds is
required.

^

When the operation is completed, the brake pedal slightly goes down. This is a normal phenomenon when the solenoid opens.

^

During this procedure, the pedal seems heavy, but completely depress it so that the brake fluid comes out from the bleeder plug.

^

Be sure to keep the brake pedal depressed. Never depress and release the pedal repeatedly.

(4) Tighten the bleeder plug, then release the brake pedal.
(5) Repeat steps "2" to "4" until all the air in the fluid is completely bled out.
(6) Using SST, tighten the bleeder plug completely.

SST 09023-00101
Torque: 11 N*m (112 kgf*cm, 8 ft.*lbf)

Brake Bleeding|Service and Repair|Page 6769 > < Brake Bleeding|Service and Repair|Page 6767