GS 350 RWD V6-3.5L (2GR-FSE) (2007)
SST 09843-18040
3. Check that the steering wheel is in the straight-ahead position and move the shift lever to the P position.
NOTE: DTC C1210/36 and C1336/39 will be recorded if the shift lever is not in the P position.
b. Obtain the zero point of the yaw rate and acceleration sensor.
1. Turn the engine switch on (IG).
2. Keep the vehicle in a stationary condition on a level surface for 2 seconds or more.
3. Check that the ABS and brake control warning lights blink and "VSC TEST MODE" is indicated on the multi-information display (Test
Mode).
HINT:
-
If the ABS and brake control warning lights do not blink and "VSC TEST MODE" is not indicated on the multi-information display,
perform zero point calibration again.
-
The zero point calibration is performed only once after the system enters the Test Mode.
-
Calibration cannot be performed again until the stored data is cleared.
c. Turn the engine switch off and disconnect SST from the DLC3.