GS 350 RWD V6-3.5L (2GR-FSE) (2007)
NOTICE:
^
Be sure to replace the 2 bolts labeled C with new ones or reuse them after applying adhesive.
Adhesive: Toyota Genuine Adhesive 1344, Three Bond 1344 or equivalent
^
Make sure that there is no oil on the threads of bolt A.
2. INSTALL NO. 2 IDLER PULLEY SUB-ASSEMBLY
3. INSTALL V-RIBBED BELT TENSIONER ASSEMBLY (for 2WD)
4. INSTALL V-RIBBED BELT TENSIONER ASSEMBLY (for 4WD)
5. INSTALL WATER PUMP PULLEY
(a)
Temporarily install the pulley with the 4 bolts.
(b) Using SST, hold the pulley and tighten the 4 bolts.
SST 09960-10010 (09962-01000, 09963-00700)
Torque: 21 N*m (214 kgf*cm, 15 ft.*lbf)
6. INSTALL WATER INLET
(a)
Install a new gasket to the water inlet housing.
(b) Install a new O-ring to the water outlet pipe.
(c)
Install the water inlet with the 4 bolts and nut.
Torque: 10 N*m (102 kgf*cm, 7 ft.*lbf)
NOTICE: Be careful not to allow the O-ring to get caught between other parts.