GS 350 RWD V6-3.5L (2GR-FSE) (2007)
a. Remove the 2 nuts and ECM.
INSTALLATION
1. INSTALL ECM
a. Install the ECM to the ECM box.
NOTE:
-
Install the ECM in the ECM box with the name plate facing the inside of the vehicle.
-
Make sure that there is no foreign matter on the gasket surface of the ECM box.
-
Insert the stud bolt in the vehicle rear side to the ECM first.
-
Make sure that the stud bolts are securely installed into the front and rear bolt holes.
b. Install the 2 nuts in the order shown in the illustration.
Torque: 5.5 N.m (56 kgf.cm, 49 in.lbf)