lexus Workshop Repair Guides

Lexus Workshop Service and Repair Manuals

SRS Service Tips|Page 9653 > < SRS Service Tips|Page 9651
Page 5
background image

b. With the front seat airbag assembly removed from the vehicle, perform a visual check. If there are any defects as mentioned below, replace the

front seat airbag assembly with a new one:
-

Cuts, minute cracks or marked discoloration on the front seat airbag assembly.

-

Cracks or other damage to the wire harness or connector.

CAUTION:  For removal and installation procedures of the front seat airbag assembly. Be sure to follow the correct procedure.

Rear Airbag Sensor

ON-VEHICLE INSPECTION 

1. INSPECT REAR AIRBAG SENSOR (VEHICLE NOT INVOLVED IN COLLISION)

a. Perform a diagnostic system check.

2. INSPECT REAR AIRBAG SENSOR (VEHICLE INVOLVED IN COLLISION AND AIRBAG HAS NOT DEPLOYED)

a. Perform a diagnostic system check.
b. When the quarter panel of the vehicle or its area is damaged, check if there is any damage to the rear airbag sensor. If there are any defects as

mentioned below, replace the rear airbag sensor with a new one:
-

Cracks, dents or chips on the sensor housing.

-

Cracks or other damage to the connector.

-

Peeling off of the label or damage to the serial number.

CAUTION:  For removal and installation procedures of the rear airbag sensor. Be sure to following the correct procedure. 

3. INSPECT REAR AIRBAG SENSOR (VEHICLE INVOLVED IN COLLISION AND AIRBAG IS DEPLOYED)

a. Replace the rear airbag sensor.

CAUTION:  For removal and installation procedures of the rear airbag sensor. Be sure to follow the correct procedure. 

HINT:  The rear airbag sensor on the impacted side should be replaced after the curtain shield airbag assembly has deployed.

Rear Seat Side Airbag Assembly

ON-VEHICLE INSPECTION 

1. REAR SEAT SIDE AIRBAG ASSEMBLY (VEHICLE NOT INVOLVED IN COLLISION)

a. Perform a diagnostic system check.

b. With the rear seat airbag assembly installed on the vehicle, perform a visual check including the following:

Cuts, minute cracks or marked discoloration on the rear seat airbag assembly.

2. REAR SEAT SIDE AIRBAG ASSEMBLY (VEHICLE INVOLVED IN COLLISION AND AIRBAG HAS NOT DEPLOYED)

a. Perform a diagnostic system check.

SRS Service Tips|Page 9653 > < SRS Service Tips|Page 9651