GS 350 RWD V6-3.5L (2GR-FSE) (2007)
2. Place the front seat outer belt on the ground and cover it with a tire (with wheel).
NOTE: Set up the front seat outer belt as shown in the illustration.
3. Move SST at least 10 m (33 ft.) away from the wheel.
NOTE: Take care not to damage the SST wire harness.
d. Activate the seat belt pretensioner.
1. Connect SST red clip to the battery's positive (+) terminal and the black clip to the battery's negative (-) terminal.
2. Check that no one is within 10 m (33 ft.) of the wheel.
3. Press the SST activation switch to activate the seat belt pretensioner.
HINT: The seat belt pretensioner operates at the same time the SST activation switch's LED illuminates.
e. Dispose of the front seat outer belt (with the seat belt pretensioner).
CAUTION:
-
Do not touch the front seat outer belt for at least 30 minutes after the seat belt pretensioner has been activated. It is very hot.
-
Use gloves and safety glasses when handling a front seat outer belt whose pretensioner has been activated.
-
Always wash your hands with water after completing the disposal.
-
Do not apply water to a front seat outer belt that has an activated pretensioner.
1. Remove the tire (with wheel) and SST.
2. Place the front seat outer belt in a plastic bag, tie the end tightly and dispose of it in the same way as other general parts.
Rear Seat Outer Belt Assembly
DISPOSAL