GS 350 RWD V6-3.5L (2GR-FSE) (2007)
Rear Seat Outer Belt Assembly
REAR SEAT OUTER BELT ASSEMBLY
REMOVAL
HINT:
-
Use the same procedures for the RH side and LH side.
-
The procedures listed are for the RH side.
-
A bolt without a torque specification is shown in the standard bolt chart.
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative battery terminal to prevent airbag and seat belt
pretensioner activation.
2. REMOVE REAR SEAT CUSHION ASSEMBLY
3. REMOVE REAR SEAT HEADREST ASSEMBLY RH AND LH
4. REMOVE REAR SEATBACK ASSEMBLY
5. REMOVE REAR DOOR SCUFF PLATE
6. REMOVE REAR SEAT SIDE GARNISH
7. REMOVE ROOF SIDE GARNISH
8. REMOVE REAR SEAT OUTER BELT ANCHOR
a. Remove the bolt and anchor part of the rear seat outer belt assembly.