GS 350 RWD V6-3.5L (2GR-FSE) (2007)
c. Turn the engine switch off and disconnect the intelligent tester.
4. CLEAR ZERO POINT CALIBRATION (WHEN USING SST CHECK WIRE:)
a. Turn the engine switch on (IG).
b. Using SST, connect and disconnect terminals TS and CG of the DLC3 4 times or more within 8 seconds.
SST 09843-18040
c. Check that the multi-information display indicates the normal system code.
d. Remove the SST from the terminals of the DLC3.
e. Using a check wire, perform zero point calibration of the yaw rate and acceleration sensor.
5. PERFORM ZERO POINT CALIBRATION OF YAW RATE AND ACCELERATION SENSOR (WHEN USING SST CHECK WIRE:)
NOTE:
-
While obtaining the zero point, do not vibrate the vehicle by tilting, moving or shaking it and keep it stationary. (Do not start the engine.)
-
Be sure to do this on a level surface (with an inclination of less than 1°).
a. Procedures for test mode.
1. Turn the engine switch off.
2. Using SST, connect terminals TS and CG of the DLC3.
SST09843-18040
3. Check that the steering wheel is centered and move the shift lever to the P position.