GS 350 RWD V6-3.5L (2GR-FSE) (2007)
2. Connect the connector of the brake pedal stroke sensor assembly.
3. Connect negative battery terminal.
4. Connect the intelligent tester to the DLC3.
5. Turn the engine switch on (IG). Reading the stroke sensor 1 value shown on the data monitor, turn the stroke sensor slowly to the right and
left to adjust it to the standard voltage.
Standard voltage: 0.8 to 1. 2 V 6.
6. Fully tighten the 2 nuts.
Torque: 8.5 N.m (86 kgf.cm, 75 in.lbf)
NOTE: Do not depress the brake pedal after turning the engine switch on (IG).
2. INSTALL INSTRUMENT PANEL NO.1 AIR BAG ASSEMBLY LOWER
3. INSTALL INSTRUMENT PANEL NO.1 SAFETY PAD SUB ASSEMBLY
4. INSTALL INSTRUMENT PANEL NO.1 UNDER COVER SUB-ASSEMBLY
5. INSTALL INSTRUMENT SIDE PANEL LH
6. INSTALL FRONT DOOR OPENING TRIM COVER LH
7. INSTALL FRONT DOOR SCUFF PLATE LH
8. INSTALL INSTRUMENT PANEL FINISH PANEL END LH
9. INSTALL CONSOLE UPPER PANEL SUB-ASSEMBLY
10. INSTALL CONSOLE UPPER PANEL GARNISH FRONT
11. PERFORM INITIALIZATION
Some systems need initialization after reconnecting the cable to the negative battery terminal.