GS 350 RWD V6-3.5L (2GR-FSE) (2007)
/Page-333002.png)
a. Using a "Torx" socket wrench (T30), remove the "Torx" screw and seat position sensor with sensor protector.
b. Disconnect the connector.
c. Separate the seat slide position sensor protector from the seat position sensor.
INSTALLATION
1. INSTALL SEAT POSITION SENSOR
a. Check that the engine switch is off.
b. Check that the negative battery (-) terminal is disconnected.
CAUTION: After disconnecting the negative battery terminal, wait for at least 90 seconds before starting the operation.
