GS 350 RWD V6-3.5L (2GR-FSE) (2007)
Acceleration Sensor: Service and Repair
Front Acceleration Sensor
REMOVAL
NOTE:
-
Do not drop the acceleration sensor. If it is dropped, replace it with a new one.
-
The acceleration sensor removed from the vehicle must not be placed upside down.
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt
pretensioner activation.
2. REMOVE FRONT DOOR SCUFF PLATE LH
3. REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
4. REMOVE FRONT DOOR OPENING TRIM COVER LH
5. REMOVE FRONT ACCELERATION SENSOR ASSEMBLY
a. Disconnect the sensor connector.
b. Remove the nut and acceleration sensor.
6. REMOVE FRONT ACCELERATION SENSOR
a. Remove the nut and sensor from the bracket.
INSTALLATION
NOTE:
-
Do not drop the acceleration sensor. If it is dropped, replace it with a new one.
-
The acceleration sensor removed from the vehicle must not be placed upside down.
1. INSTALL FRONT ACCELERATION SENSOR