GS 350 RWD V6-3.5L (2GR-FSE) (2007)
3. REMOVE REAR FLOOR SIDE MEMBER COVER
(a)
Remove the 2 screws and the rear floor side member cover LH.
4. REMOVE REAR NO.1 SUSPENSION ARM
(a)
Remove the 2 bolts, 2 nuts and rear No.1 suspension arm.
NOTICE:
Turn the bolt while holding the nut.
INSTALLATION
1. TEMPORARILY TIGHTEN REAR NO.1 SUSPENSION ARM
(a)
Temporarily install the rear No.1 suspension arm with the 2 bolts and 2 nuts.
2. STABILIZE SUSPENSION
(a)
Jack up the axle carrier, with a wooden block placed between the jack and axle carrier, to apply load to the rear suspension so that the rear
drive shaft assembly becomes level.