GS 350 RWD V6-3.5L (2GR-FSE) (2007)
Damping Control Actuator: Service and Repair
Absorber Control Actuator (For Front Side)
REMOVAL
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt
pretensioner activation.
2. REMOVE COOL AIR INTAKE DUCT SEAL
3. REMOVE ENGINE ROOM SIDE COVER RH
4. REMOVE ENGINE ROOM SIDE COVER LH
5. REMOVE SHOCK ABSORBER CAP UPPER
a. Remove the 3 nuts and shock absorber cap upper.
b. Disconnect the connector.
6. REMOVE ABSORBER CONTROL ACTUATOR
a. Turn the absorber control actuator counterclockwise 40° to remove it from the front shock absorber with coil spring.
INSTALLATION
1. INSTALL ABSORBER CONTROL ACTUATOR
a. Install the absorber control actuator to the actuator support bracket.