GS 350 RWD V6-3.5L (2GR-FSE) (2007)
6. CONNECT HEIGHT CONTROL SENSOR LINK SUB-ASSEMBLY FRONT
(a)
Connect the height control sensor link sub-assembly front with the nut.
Torque: 5.4 N*m (55 kgf*cm, 48 in.*lbf)
7. STABILIZE SUSPENSION
(a)
Install the front wheels.
Torque: 103 N*m (1,050 kgf*cm, 76 ft.*lbf)
(b) Lower the vehicle and bounce it up and down several times to stabilize the front suspension.
(c)
Remove the front wheels.
(d) Jack up the front suspension lower arm placing a wooden block in between. Apply a load to the front suspension so that the front suspension
lower arm is placed in a horizontal position.
8. FULLY TIGHTEN FRONT SHOCK ABSORBER WITH COIL SPRING
(a)
Fully tighten the bolt on the lower side of the front shock absorber while holding the nut.
Torque: 157 N*m (1,600 kgf*cm, 116 ft.*lbf)
9. REMOVE ENGINE ROOM SIDE COVER
10. REMOVE FRONT WHEEL
Torque: 103 N*m (1,050 kgf*cm, 76 ft.*lbf)
11. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
12. INSPECT AND ADJUST FRONT WHEEL ALIGNMENT
13. PERFORM INITIALIZATION
DISPOSAL