GS 350 RWD V6-3.5L (2GR-FSE) (2007)
8. SEPARATE TIE ROD ASSEMBLY (for 4WD)
9. REMOVE FRONT AXLE HUB SUB-ASSEMBLY (for 2WD)
a. Remove the 4 bolts, front axle hub sub-assembly and front disc brake dust cover.
10. REMOVE FRONT AXLE HUB SUB-ASSEMBLY (for 4WD)
a. Using a plastic hammer, separate the front drive shaft assembly from the front axle hub.
NOTICE: Be careful not to damage the drive shaft boot.
b. Remove the 4 bolts, front axle hub sub-assembly and front disc brake dust cover.
INSTALLATION
1. INSTALL FRONT AXLE HUB SUB-ASSEMBLY (for 2WD)
a. Install the front axle hub sub-assembly and front disc brake dust cover with the 4 bolts.
Torque: 69 Nm (700 kgf-cm, 51 ft. lbs.)
2. INSTALL FRONT AXLE HUB SUB-ASSEMBLY (for 4WD)
a. Install the front axle hub sub-assembly and front disc brake dust cover with the 4 bolts.
Torque: 69 Nm (700 kgf-cm, 51 ft. lbs.)
b. Install the front drive shaft assembly to the front axle hub sub-assembly.
NOTICE: Be careful not to damage the front drive shaft boot.