GS 400 V8-4.0L (1UZ-FE) (1999)
![background image](/lexus/gs_400/v8-4.0l_(1uz-fe)/Page-1917002.png)
C. Install the SST.
1. Connect the 2 SST each other, then connect them to the airbag connector of the front seat.
SST 09082-00700, 09082-00750
NOTE: To avoid damage to the SST connector and wire harness, do not lock the secondary lock of the twin lock.
2. Move the SST at least 10 m (33 ft) away from the front of the vehicle.
3. Close all the doors and windows of the vehicle.
NOTE: Take care not to damage the SST wire harness.
4. Connect the SST red clip to the battery positive (+) terminal and the black clip to the battery negative (-) terminal.
D. Deploy the airbag.
1. Check that no one is inside the vehicle or within 10 m (33 ft) area around the vehicle.
2. Press the SST activation switch and deploy the airbag.
HINT: The airbag deploys simultaneously as the LED of SST activation switch lights up.
E. Dispose of side airbag assembly.
CAUTION:
-
The side airbag assembly is very hot when the airbag is deployed, so leave it alone for at least 30 minutes after deployment.
-
Use gloves and safety glasses when handling a side airbag assembly with the deployed airbag.
-
Do not apply water, etc. to a side airbag assembly with the deployed airbag.
-
Always wash your hands with water after completing the operation.
When scrapping a vehicle, deploy the airbag and scrap the vehicle with the side airbag assembly still installed.
Deployment When Disposing of Side Airbag Assembly
CAUTION: