GS 450h V6-3.5L (2GR-FSE) Hybrid (2007)
Distance Sensor: Adjustments
ADJUSTMENT
1. REMOVE COOL AIR INTAKE DUCT SEAL
2. REMOVE ENGINE UNDER COVER
3. REMOVE FRONT FENDER LINER LH
4. REMOVE FRONT FENDER LINER RH
5. REMOVE FRONT BUMPER COVER
6. ADJUST MILLIMETER WAVE RADAR SENSOR ASSEMBLY
CAUTION: Exposure to radio frequency emissions is hazardous to your health. It is hazardous to your health to be within 20 cm (7.9 in.)
of the device's radio frequency aperture.
NOTE:
-
This device complies with FCC radio frequency emission regulations.
-
Perform measurements on a level surface.
-
Make sure that no large pieces of metal are within a 10 m (32.81 ft.) x 14 m (45.93 ft.) area in front of the vehicle. If possible, the
surrounding area should also be free of large metal objects.
a. Before adjusting the radar beam axis, prepare the vehicle as follows.
1. Check the tire pressure and adjust it if necessary.
2. Remove all excess weight from the vehicle (luggage, heavy objects, etc.).
b. w/ Air suspension:
Adjust the vehicle's height to the standard height.
c. Check and adjust the vertical direction of the radar sensor.
1. Remove dust, oil and foreign matter from the radar sensor's level rack.
2. Set a level on the radar sensor's level rack.