GS 450h V6-3.5L (2GR-FSE) Hybrid (2007)
_hybrid/Page-1932009.png)
a. Detach the clip labeled A from the vehicle body. Pull the pillar garnish so that the tip of clip B locks in the pillar garnish's hole.
b. Using needle-nose pliers, rotate clip B 90° and remove the pillar garnish.
c. Remove the clip A from the vehicle body.
d. Protect the curtain shield airbag.
1. Thoroughly cover the airbag with a cloth or nylon sheet that is 700 mm (27.56 in.) x 120 mm (4.72 in.) and fix the ends of the cover with
adhesive tape, as shown in the illustration.
NOTICE: Cover the curtain shield airbag with a protective cover as soon as the front pillar garnish is removed.
15. REMOVE FRONT PILLAR GARNISH RH
HINT: Use the same procedures described for the LH side.
