GS 450h V6-3.5L (2GR-FSE) Hybrid (2007)
Initialization Procedure
1.
Without depressing the brake pedal, push the engine START/STOP switch twice to select the "IG-ON" mode.
2.
Push and hold the sliding roof switch to the "UP" side or the "CLOSE" side until the following cycle of the sliding roof operation is completed:
A.
Closed position
B.
Fully tilt up
C.
Fully tilt down
D.
Fully slide open
E.
Fully slide close
After the cycle of operation above is completed, initialization is complete.
3.
Check for proper operation of the "one-touch slide open and close" and "one-touch tilt up and down" functions by pushing the switch briefly to the
"OPEN" and "UP" positions.
NOTE:
Jam protection is enabled through the above initialization procedure.