GS 450h V6-3.5L (2GR-FSE) Hybrid (2007)
Sunroof / Moonroof Module: All Technical Service Bulletins
Body - Power Sliding Roof Initialization Procedure
PRE-DELIVERY SERVICE
PD013-06
REVISED
Title:
INITIALIZATION OF SLIDING ROOF
DURING PDS
Models:
'07 GS 450h
March 3, 2006
TSIB REVISION NOTICE:
^
December 4, 2006: Applicable Vehicles has been updated.
Previous versions of this TSIB should be discarded.
Introduction
Initialize the sliding roof after installing the DCC fuse in its original location during Pre-Delivery Service (PDS).
The installation of the DCC fuse, and the initialization procedure shown below, will enable the operation of the ~one-touch slide open and close "
"one-touch tilt up and down," and "jam protection" functions of the sliding roof.
NOTE:
Any time the battery terminal has been disconnected, the sliding roof must be re-initialized.
Applicable Vehicles
^
2007 model year GS 450h vehicles produced before July.
NOTE:
Initialization is NO longer necessary on GS 450h vehicles produced after July due to the addition of non-volatile memory.
Warranty Information