GS 450h V6-3.5L (2GR-FSE) Hybrid (2007)
3. REMOVE REAR BRAKE FLEXIBLE HOSE
(a)
Remove the brake tube with SST while holding the flexible hose with a wrench.
SST 09023-00101
NOTICE:
^
Do not bend or damage the brake tube.
^
Do not allow any foreign matter such as dirt and dust to enter the brake tube from the connecting points.
(b) Remove the clip.
(c)
Remove the union bolt, flexible hose and gasket.
INSTALLATION
HINT:
^
Use the same procedures for the LH side and RH side.
^
The procedures listed below are for the LH side.
CAUTION: When the brake caliper is removed from the brake disc, do not start the hybrid system. If the hybrid system is started, the brake
fluid pressure may increase.
1. INSTALL REAR BRAKE FLEXIBLE HOSE
(a)
Connect the flexible hose with the union bolt and a new gasket.
Torque: 30 N*m (306 kgf*cm, 22 ft.*lbf)
NOTICE: Install the flexible hose lock securely in the lock hole in the disc brake caliper.
(b) Connect the brake tube to flexible hose with SST while holding flexible hose with a wrench.
SST 09023-00101
Torque:
15 N*m (155 kgf*cm, 11 ft.*lbf) without SST