GS 450h V6-3.5L (2GR-FSE) Hybrid (2007)
d. Using SST, connect each brake tube to the correct positions of the actuator with bracket as shown in the illustration.
SST 09023-00101
Torque:
15 N.m (155 kgf.cm, 11 ft.lbf) without SST
14 N.m (144 kgf.cm, 10 ft.lbf) with SST
HINT:
-
Use a torque wrench with a fulcrum length of 300 mm (11.81 in.).
-
This torque value is effective when SST is parallel to a torque wrench.
e. Connect the No. 1 reservoir tube with the clip.
2. INSTALL SKID CONTROL ECU
3. INSTALL ENGINE ROOM NO. 3 RELAY BLOCK
4. INSTALL FRONT WHEEL
5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
6. DISABLE BRAKE CONTROL
7. FILL RESERVOIR WITH BRAKE FLUID
8. BLEED AIR FROM NO. 1 RESERVOIR TUBE
9. INSTALL ABS MOTOR RELAY