GS 450h V6-3.5L (2GR-FSE) Hybrid (2007)
3. Check that the level's air bubble is within the red frame.
OK: Level's air bubble is within red frame.
If the bubble is not within the red frame, use a hexagon wrench to adjust screw A until the air bubble is within the red frame.
HINT:
-
The adjustable range within the level's red frame is ±0.2°.
-
The target angle is +0.2° (upward angle of 0.2°).
d. Adjust the reflector height.
1. Adjust the reflector so that the center of the SST reflector is the same height as the millimeter wave radar sensor.
SST 09870-60000
HINT: Prepare a 10 m (32.81 ft.) string, a string with a sharp-pointed weight (plumb bob), and a 5 m (16.41 ft.) tape measure.
e. Place the reflector.
1. Hang the string (with weight) from the center of the vehicle rear's emblem. Mark the vehicle rear's center point on the ground. Repeat for
the front of the vehicle.