GS 450h V6-3.5L (2GR-FSE) Hybrid (2007)
3. REMOVE FAN AND GENERATOR V BELT
(a)
Rotate the tensioner pulley counterclockwise to loosen the belt tension. Then remove the V belt.
NOTICE:
^
The pulley bolt for the belt tensioner has a left-handed thread.
^
Do not perform this procedure from underneath the vehicle, as the tensioner may be damaged.
INSTALLATION
1. INSTALL FAN AND GENERATOR V BELT
(a)
Rotate the tensioner pulley counterclockwise, and then install the V belt as shown in the illustration.
NOTICE: Check that the drive belt is properly set to each pulley.
2. INSTALL NO. 1 AIR CLEANER INLET
(a)
Install the air cleaner inlet with the bolt.
Torque: 5.0 N*m (51 kgf*cm, 44 in.*lbf)
3. INSTALL COOL AIR INTAKE DUCT SEAL