GS 450h V6-3.5L (2GR-FSE) Hybrid (2007)
3. CONNECT NO.1 COOLER REFRIGERANT DISCHARGE HOSE
a. Remove the attached vinyl tape from the hose.
b. Sufficiently apply compressor oil to a new O-ring and the fitting surface of the cooler compressor.
Compressor oil: ND-OIL 11 or equivalent
c. Install the O-ring on the cooler refrigerant discharge hose.
d. Connect the cooler refrigerant discharge hose to the cooler compressor with the bolt.
Torque: 9.8 N.m (100 kgf.cm, 7 ft.lbf)
4. CONNECT NO.1 COOLER REFRIGERANT SUCTION HOSE
a. Remove the attached vinyl tape from the hose.
b. Sufficiently apply compressor oil to a new O-ring and the fitting surface of the cooler compressor.
Compressor oil: ND-OIL 11 or equivalent
c. Install the O-ring on the cooler refrigerant suction hose.
d. Connect the cooler refrigerant suction hose to the cooler compressor with the bolt.
Torque: 9.8 N.m (100 kgf.cm, 7 ft.lbf)
5. INSTALL ENGINE UNDER COVER
6. INSTALL V-BANK COVER
7. INSTALL ENGINE ROOM SIDE COVER LH
8. INSTALL COOL AIR INTAKE DUCT SEAL
9. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
10. CHARGE REFRIGERANT
11. WARM UP ENGINE
12. CHECK FOR LEAKAGE OF REFRIGERANT