GS 450h V6-3.5L (2GR-FSE) Hybrid (2007)
c. Remove the 6 bolts, nut and ECM bracket.
9. REMOVE HYBRID VEHICLE CONTROL ECU
a. Raise the lock lever and disconnect the 2 connectors. Remove the hybrid vehicle control ECU.
NOTE: Make sure that the lock lever is raised 90° as shown in the illustration before disconnecting the connectors. Failure to do this may
cause the connectors to break.
INSTALLATION
1. INSTALL HYBRID VEHICLE CONTROL ECU
a. Connect the 2 connectors to the hybrid vehicle control ECU and push each lock lever down to lock the connectors.
NOTE:
-
Make sure that the lock lever is raised 90° before connecting the connectors. Failure to do this may cause the lock lever and terminals to
break.