GS 450h V6-3.5L (2GR-FSE) Hybrid (2007)
_hybrid/Page-394003.png)
5. INSPECT WHEEL ANGLE
(a)
Turn the steering wheel fully to the left and right and measure the turning angle.
Standard wheel turning angle
If the right and left inside wheel angles differ from the specified range, check the right and left rack end lengths.
6. INSPECT CAMBER, CASTER AND STEERING AXIS INCLINATION
(a)
Put the front wheels on the center of the alignment tester.
(b) Remove the center ornament.
(c)
Install the camber-caster-steering axis inclination gauge at the center of the axle hub or drive shaft.
(d) Inspect the camber, caster and steering axis inclination.
Standard camber inclination: -0°26' ± 45' (-0.43° ± 0.75°)
Right-left error: 30' (0.5°) or less
Standard caster inclination: 7°26' ± 45' (7.43° ± 0.75°)
Right-left error: 30' (0.5°) or less
Standard steering axis inclination: 9°26' ± 45' (9.43° ± 0.75°)
Right-left error: 30' (0.5°) or less
NOTICE:
^
Inspect while the vehicle is empty.
^
The maximum tolerance of right and left difference for the camber and caster is 30' or less.
(e)
Remove the camber-caster-steering axis inclination gauge and attachment.
(f)
Install the center ornament.
If the caster and steering axis inclination are not within the specified values, after the camber has been correctly adjusted, recheck the
suspension parts for damaged and/or worn out parts.
