GS 450h V6-3.5L (2GR-FSE) Hybrid (2007)
^
Make sure that SST is securely set to the rear axle carrier spacer.
^
If the rear axle carrier spacer has come off, replace the rear axle carrier with a new one.
^
Make sure that the string of SST is securely tied to the vehicle.
16. REMOVE REAR UPPER NO. 1 CONTROL ARM ASSEMBLY
(a)
Jack up the rear axle so that the bolt on the rear upper No. 1 control arm can be removed.
HINT:
Place a wooden block between the jack and rear axle carrier to prevent damage to the rear axle carrier.
(b) Remove the bolt, washer and nut, and the rear upper No. 1 control arm from the rear axle carrier.
17. REMOVE REAR NO. 1 SUSPENSION ARM ASSEMBLY
(a)
Remove the bolt and nut, and separate the rear suspension arm from the rear axle carrier.
NOTICE:
Turn the bolt while holding the nut.
18. REMOVE REAR NO. 2 SUSPENSION ARM ASSEMBLY
(a)
Remove the bolt and nut, and separate the rear No. 2 suspension arm from the rear axle carrier.
NOTICE:
Turn the bolt while holding the nut.
19. DISCONNECT TOE CONTROL LINK SUB-ASSEMBLY
(a)
Remove the nut from the toe control link.