GS 450h V6-3.5L (2GR-FSE) Hybrid (2007)
NOTE:
- The idling speed in inspection mode is approximately 1,000 rpm.
- The engine speed increases to 1,500 rpm if the accelerator pedal is depressed less than 60%. If the accelerator pedal is depressed
more than 60%, the engine speed increases to 2,500 rpm.
- If a DTC is set during inspection mode, the master warning light illuminate.
- When the master warning light illuminates during inspection mode, deactivate inspection mode, and check for DTC(s).
e. Activating inspection mode (not using intelligent tester):
1. Turn the power switch ON (IG).
2. Move the shift lever to the P position, and then depress the accelerator pedal fully twice.
3. Move the shift lever to the N position, and then depress the accelerator pedal fully twice.
4. Move the shift lever to the P position, and then depress the accelerator pedal fully twice.
NOTE: The above 3 procedures should be operated within 60 seconds.
5. Check that "MAINTENANCE MODE" is displayed on the multi-information display.
6. Turn the power switch ON (READY), and the "READY" light is illuminated in the combination meter.
NOTE:
- The idling speed in inspection mode is approximately 1,000 rpm.
- The engine speed increases to 1,500 rpm if the accelerator pedal is depressed less than 60%. If the accelerator pedal is depressed
more than 60%, the engine speed increases to 2,500 rpm.
- If a DTC is set during inspection mode, the master warning light illuminate.
- When the master warning light illuminates during inspection mode, deactivate inspection mode, and check for DTC(s).
f.
Deactivating inspection mode
1. Turn the power switch OFF.
NOTE: Driving the vehicle without deactivating inspection mode may damage the transmission.
Continuity and Resistance Check
CONTINUITY AND RESISTANCE CHECK
a. Disconnect the battery terminal or wire so there is no voltage between the check points.
b. Contact the two leads of an ohmmeter to each of the check points.